Syntec's premium Core Bit is designed to get the job done. Whether it is retiling a bathroom at home or you're a contractor tiling a new hotel. This efficient crown makes the perfect hole in ceramic, porcelain, marble and granite. Ideal for piping work such as water, electricity, gas, air conditioning and drainage.

Using the Tile Core Bit is as easy as 1,2,3. Please follow these instructions and take your time to learn how to best use this Syntec coring bit.

The core bit requires a drill motor with a 3/8" drill chuck, but is not intended for use with hammer action drill.

Layout utility holes on the surface of the material to be drilled and surround the intended hole with masking tape to reduce chipping.

Start the hole by drilling on a slight angle until the drill has began to penetrate the surface, and then straighten the core drill gradually.

When drilling, apply light pressure to allow core drill to penetrate materials without forcing and causing core bit to over heat.

Before coring your next hole, remove material from center of the core drill. BEWARE - core drill and material will be extremely hot immediately after drilling and will cause severe injury if handled before core drill and material have had time to cool.

To maximize drilling speed and performance add a small amount of water to the surface of the material around the core drill. CAUTION - Keep all water away from drill motor and all other electrical connections.

Safety is important so please follow these simple rules:
Wear eye safety glasses.
Wear a dust mask.
Make sure to have sufficient ventilation at all times.
Remove all loose material before beginning and during the grinding process.
Read the instruction manual for the tool you are using and follow the manufacturer's directions for the use and maintenance.